The dotted marks on the part of the mat that is inserted are hidden by material that was attached.
Brother scan and cut mat not recognised.
At brother we work hard to provide customers with the highest quality items.
Then direct cut mode will not recognize it.
The scanning mat can also be used with scan to cut data function.
After a few.
The cutting pressure may be too strong.
A mat was not inserted straight into the machine.
The dotted marks on the part of the mat that is inserted are dirty.
Press on the operation panel to feed out the mat and then insert the mat straight into the machine again.
Replace the mat with a new one.
So we thank our customers who contacted us about the difficulties with scanncut dx mat feeding process.
Problem 2 there are deep cuts completely through the mat or cut through the mat.
Mats for the cm models will not work on this machine.
The mat was inserted so that the side with the material attached is facing down.
Clean the dotted marks at the edge of the mat and their surrounding areas.
The scanner glass is dirty.
You should use the scan to cut data function for images or designs that have a lot of detail or background.
Replace with a new one if the mat is not being recognized.
Touch in the settings screen once to decrease the cut pressure and then.
You helped us identify and fix the root cause.
As you i recently purchased a brother scanncut machine and while i love it there is one thing i do not love and that is the mat.
Our low tack mat and standard mat are to be used with the direct cut function.
Problem 2 and three simple solutions.
Live demonstration ii show you two new issues after using the new brother dx for about 3 weeks mats load at a kink crooked went online and read tha.
Insert the mat so that the side with the material attached is facing up.
The scan n cut machine needs to see the scanned image at its original color scheme so it can determine what part of the color range it can recognize and cut.
The mat is too sticky at first which is not a problem because you just take a clean tshirt and pat it all over the mat to remove some of the stickiness and voila.
Possible causes or results case1.
The mat was inserted so that the side with the material attached is facing down.
Problem 1 and solution.
The mat s adhesive strength may have been decreased or the material is not secured properly.
